Flat Panel Coop Heater-
The heater is for use on 12 volts. uses
only 5.5 amps, 650 watts of power. Do not cover the unit, and make sure there is nothing in front of the unit (36 inches is
safe)
This product has a built in overheat protection system. If the heater overheats, it will automatically shut off
the power.
Has an on off switch, and should b e cleaned regularly by dusting it off. Disconnect electricity and
allow the heater to cool before wiping. Do not use detergent or scrape the surface, just water will clean this just
fine.
Unit surface temperature is hot, do not touch. Use caution with any heating device. Do not use this outdoors.
The heater is not intended for use in a bathroom or bathtub where it can get wet (obviously!)
Wall mounting instructions:
Mark
the position for the mounting holes on the wall according to the dimensions. Drill the wall at the 2 marked positions. Hang
the heater in the screws.
To get good air convection, a gap of at least 4 inches to any window frame should be maintained.
The heater is fitted with 2 cable clamps. To keep the cable tidy, just remove it by simply pulling it out of it's retaining
hole. The fit it around the cable.
Poultry nesting box heater/Water defroster both 12X12 inch,
and 18X18 inch-
These items are handmade and invented by me. Patent pending. These coop heaters are made
of ceramic and should not be used cracked. The heater will heat to 90 degrees, after approximately 1 hour. The heaters
edges do not get hot, so you should not expect them to. We will replace this heater if it does not heat, within 1 year
of purchase date. You should not get these heaters wet, however they can be wiped clean. Attach the optional sticky
legs to the bottom to allow air circulation on the heater.
The 12 inch heater uses 16 ams, and the large 18 inch uses
20 amps.
If this no longer works, or arrives broken send a picture to
postmaster@shopthecoop.com
we will replace this for you free of charge within 1 year of purchase date.
Metal Heater Base and Waterer
Plugs into a 110 Volt outlet. Uses 125 watts of electric and comes
fully assembled. Place on flat surface and plug into a GFCI outlet. 3 prong grounded electrical cord and thermostat control
that automatically turns on and off for economical operation. Prevents water from freezing at temperatures as low as 10 degrees
fahrenheit in metal founts, bowls and pans.
Use only in a dry sheltered area. Do not place cord or heater base near
water. Try not to use an extension cord if possible, unplug heater at receptacle when not in use. Store heater base indoors
when not in use.
Use our Metal Poultry Waterer, as Metal retains heat better than plastic. Plastic should not be used
on this, and plastic waterer's crack when they freeze.
Temperature Controller
Should
be used with any combination of heaters, not exceeding 500 watts. 12 month product warranty.
Insert heating plugs
in the temp controller. You can adjust the thermostat to range temps from 70 up. Remote 6 ft sensor cable, allows
you to move this where you need to. Model RT 500R. Has a polarized plug to reduce any chance of electrical shock. You
can turn the thermostat up or down to maintain desired temperature.
12 month warranty- items should be sent to:
Z.M.Lab,3650 Sacramento Drive, San Luis Obispo, CA 93401
Ceramic Heater Bulbs
Innovative design 99% heat efficient- Warranty is for repair or replacement
for 2 full years, from manufacturer. Rof C Hagen, who warrants
these to be free of defects in material and workmanship under normal use and service. Warranty comes with each bulb
and needs to be filled out and mailed to :
Hagen Corp. PO Box 9107 Mansfield
MA 02048
Heated Water Bowls
Uses 25 watts of power for the small bowl, 30 watts for the larger.
If using an extenstion
cord, it should be grounded. Route the power supply cord and the bowl so it is protected from pets and livestock. Always inspect
cord prior to use. Unplug when not in use. Wash with water and do not use bleach. Do not plug uint in if water can be heard
in the units houseing.
Satisfaction guaranteed by PetsUnited, Hazleton PA 18202
Outlet Temp Controllers
Maximum rating 1800 watts, 15 amps, 120 Volts
Temperature
ranges are approximate.
To be used with GFI Outlet breaker